View source for 7T Neurofeedback

Attempts at installing a neurofeedback option 23/12/2022

Authors: Wietske van der Zwaag and Johan van der Meer

Lots of info in the package from Paul de Bruin. See scdropbox/Wietske/XTC-package-v8

Given that CorbaDataDumper is installed (check C:\xtc) to run it as its own external gadget, type the following in the command line: 

* cd C:\xtc
* CorbaDataDumper 193.176.235.20 193.176.235.20 c:\CorbaDataDumps

1) Set the geometry parameter 'External control' to 'full control' and start your scan. A message 'Under remote control' will appear. 

2) Then go to c:\CorbaDataDumps\ScannerUpdates and paste in an (empty) text file called start.txt

Your scan will start.

Your data will appear in c:\CorbaDataDumps\0000 (and higher numbers for later scans)


-----------------------------
To use on an external computer 

#  install the CorbaDataDumper on your pc. It's already on the 7T stim pc. 
# set the correct IP address in the Service Application (under MR applications) - connectivity - external configuration; 
 127.0.0.1 for the scanner itself and 193.176.235.176 for the stim pc. 
#  log in as admin on the stim pc
# ping the stim pc to make sure you can see it from the scanner
# update the fussite_cs.exe.config file following instructions from the pdf (WZ did this - 23/12) (save file as 'stim pc' - put back pauls)
# now type:
* cd C:\xtc
* CorbaDataDumper 193.176.235.20 193.176.235.176 c:\CorbaDataDumps
# start your scan
# put the start.txt in CorbaDataDumps\ScannerUpdates'''

Current state: on the stim pc, the folder 'ScannerUpdates' is not made automatically. Putting a .txt file in there doesn't start the scan. All other messages look fine.